NOTE:
The optimum mounting height of the outboard motor is affected by the boat and motor combination
and the desired use. Test runs at a different height can help determine the optimum mounting height.
For further information, consult your “PARSUN” dealer or boat manufacturer.
2.1.2 Clamping the outboard motor
1. Tighten the transom clamp screw evenly and securely. Occasionally check the clamp screws for
tightness during operation of the outboard motor because they could become loose due to engine
vibration.
WARNING:
Loose clamp screws could allow the outboard motor to fall off or move on the transom.
This could cause loss of control.
Make sure the clamp screws are tightened securely. Occasionally check the screws for
tightness during operation.
8
To Next Page
Loading...
