3. Put a new gasket on the oil drain screw. Tighten the drain screw.
4. Add the correct amount of oil through the filler hole. Install the filler cap.
5. Start the engine and make sure that there are no oil leaks.
6. Turn off the engine and wait 3 minutes. Recheck the oil level using oil level check window to be sure
the level falls between the upper and lower marks.
CAUTION:
The oil should be changed more often when the engine is operated under adverse conditions such
as extended trolling.
3.6 Checking wiring and connectors
Check that each grounding wire is properly secured and each connector is engaged securely.
3.7 Checking for leakage
Check that no exhaust or water leaks from the joints between the exhaust cover, cylinder head, and body
cylinder. Check for oil leaks on the around the engine.
CAUTION:
If any leaks are found, consult your PARSUN dealer.
33
To Next Page
Loading...
Need help?
General
