English – 13
SET UP AND ADJUSTMENTS
• Assemble the support roller
cover and make sure that
blade groove is aligned with
both engagement rollers.
Then tighten the four
screws tight.
• Turn the blade and check
that the support rollers do
not have tension against
the blade.
• Adjust the support rollers so
that you easily can block the
roller with your thumb when
rotating the blade.
• Tighten the lock nuts on the
support roller cover.
• Rotate the blade and re-
check with your thumb that it
is easy to block the roller
when rotating the blade.
NB. The machine should be
placed upright.
• Tighen the knobs hard and
the machine is ready to use.
WARNING!
Inspect the blade for damage before installing
on the unit. Damaged blades can break and
cause severe injury.
!
To Next Page
Loading...
