6 – English
SAFETY INSTRUCTIONS
GENERAL SAFETY INSTRUCTIONS
3 Muffler
Never use a machine that has
a defective muffler.
Check regularly that the
muffler is secured to the
engine body.
!
!
WARNING! Never use a power cutter with
defective safety equipment. The power
cutter’s safety equipment should be checked
and maintained as described in this
Operator’s Manual. If your power cutter does
not meet any of these controls you should
contact your service workshop.
5 Blade guard for the cutting blade
Never use a defective blade
guard or a blade guard that is
not fitted correctly.
WARNING! Check that the cutting blade is
fitted correctly and does not show signs of
damage. A damaged cutting blade can cause
personal injury.
Transport and storage
• Store the power cutter in a lockable area so that it is out of
reach for children and unauthorised persons.
• Never use the machine when you are tired, under the
influence of medicines/drugs or alcohol.
• Never start a power cutter indoors. Be aware of the dangers
of inhaling the engine´s exhaust fumes.
• Do not lend out the power cutter without including this
Operator’s Manual. Ensure that the person who intends to
use the power cutter understands the information in the
Operator’s Manual.
Intended use
IMPORTANT INFORMATION!
A power cutter is designed to cut hard materials such
as concrete/stone. Observe the increased risk of
kickback when cutting soft materials.
Do not use the power cutter until you have read the
entire contents of this Operator´s Manual.
All servicing, in addition to the points listed in the
section "
Control, maintenace and service of the power
cutter´s safety equipment
", should be carried out by
trained service specialists.
4 Throttle lock
1 Make sure the throttle
control is locked at the
idle setting when you
release the throttle lock.
2 Press the throttle lock and
make sure it returns to its
original position when you
release it.
3 Check that the throttle
control and throttle lock
move freely and that the
return springs work
properly.
4 Start the power cutter and
apply full throttle. Release
the throttle control and
check that the blade stops
and remains stationary. If
the blade rotates when
the throttle is on idle
setting you should check
the carburettor idle
adjustment. See the
section on
”Maintenance”
.
To Next Page
Loading...