7
Safety Instructions
WARNING
7. NEVER OPERATE THE TOOL WITH THE
WORK CONTACT ELEMENT REMOVED OR
DISABLED.
NEVER operate the tool if the work contact element
is not working properly.
8.
Pull the follower slightly back and push the release
lever. Tip the tool nose up slightly and fasteners should
slide out of the rear of the magazine. If fasteners are
jammed, refer to the appropriate servicing section of
this manual.
9.
NEVER OPERATE THE IMPULSE
BRADDER IF
PARTS ARE LOOSE, DAMAGED OR MISSING.
10. DO NOT DRIVE FASTENERS INTO KNOTS OR ON
TOP OF OTHER FASTENERS.
A fastener may ricochet and cause serious injury.
11. OPERATE THE TOOL ONLY ON THE WORKPIECE.
1.
Eye protection must meet the requirements of
AS/NZS
1337:1992 and should have side
shields for increased
2. NEVER ASSUME THE TOOL IS EMPTY.
Never point the tool at yourself or anyone else.
3. NEVER ENGAGE IN "HORSEPLAY" WITH THE
TOOL.
Careless and improper use may result in a serious
accident.
4. NEVER CARRY THE TOOL WITH YOUR FINGER ON,
OR SQUEEZING, THE TRIGGER.
This practice may result in the accidental discharge of
a fastener.
5. NEVER OPERATE A MALFUNCTIONING TOOL.
Refer to the servicing or troubleshooting section of this
manual to correct the problem. If the problem cannot
be corrected, stop using the tool and contact Paslode.
®
6. DO NOT LOAD FASTENERS WITH THE TRIGGER
AND/OR WORK CONTACT ELEMENT DEPRESSED.
A fastener may be accidentally discharged.
WARNING
should be operated only
when it is in contact with
the work
surface.
When
fastening thin materials
such as plywood, be sure
to position the tool so that
the fastener is driven into
the underlying piece.
ALWAYS POINT THE TOOL AWAY FROM YOUR-
SELF AND OTHERS WHEN CLEARING A JAM OR
REMOVING FASTENERS. ALWAYS REMOVE THE
Always wear EYE and EAR
safety gear when working
with or in the vicinity of the
Paslode
Impulse Bradder.
protection.
FUEL CELL AND BATTERY BEFORE CHECKING
THE TOOL.
The Impulse Angled Bradder
To Next Page
Loading...
