PAT DS350 - Central Unit Connection and Wiring Procedures; Strain Relief Installation

Console Replacement Instructions
PROCEDURE 2. STRAIN RELIEF INSTALLATION
1. Remove existing cable, ferrite filter and strain relief from central unit. (Fig. 5)
2. Insta
ll the new PG13.5 RED/WHT strain relief using the existing PG13.5 nut, from the strain
relief just removed.
3. Reinstall ferrite filter. (Fig. 5a).
Note: Outer shield is grounded at strain relief insert.
Fig. 5
Fig. 5a
SkyAzúl, Equipment Solutions
5
www.skyazul.com