Advance Paper
1. Press the white and gray advance paper button located to the left of the paper holder, as shown
below:
The paper will advance approximately 1/3” with each push of the button.
Note: The terminal must be connected to power to use the advance paper button. The button
will not work when the E500 is battery powered.
Tear Paper
When connected to power, the E500 automatically cuts excess paper when the paper holder is closed.
However, if the E500 is running on battery power, you can tear the paper by hand.
1. Tilt the paper toward the bottom of the terminal at about a 45-degree angle.
2. Pull the paper from the left or right across the tear off bar inside the terminal.
To Next Page
Loading...
