PAX E500 - AC Power Connection

PAX E500 INSTALLATION MANUAL
13
20181002-v0.5
PAX Technology®
Customer Support support@pax.us
(877) 859-0099
www.pax.us
AC Power Connection
The terminal uses a two-piece AC power supply and cord. It is highly recommended to use surge
protection and a UPS backup power supply with battery backup.
To apply power:
1. Connect the two-piece power supply and power cable together.
2. Plug the round power connector with the semi-circle plug into the terminal power port.
3. Route the power cord through the cable retention slot located at the bottom of the terminal.
4. After all terminal cables are connected, plug the terminal AC power cable to the power source.
WARNING:
DO NOT connect the other end to the AC power source until all the other cables are
connected first. Plugging in the AC power cord to the power source before the other cables
are installed may result in damage to the terminal or connected devices.
WARNING:
Do not disconnect the power supply while applications are being downloaded to the terminal.
The applications could be downloaded improperly or the Flash memory could be damaged.