Note: The white plastic arrow slots on the battery connector, as shown below, must face
toward you when you insert it into the battery port.
7. Firmly seat the white battery connector into its socket.
8. Insert the two tabs on the battery cover plate and slide the cover plate into place.
9. Tighten the captive screw on the cover plate.
Cable Lock (If Required)
To install a cable lock:
1. Insert a customer-provided cable lock into the K-Slot® on the terminal.
2. Loop the cable around a permanent object and secure in place.
Note: The K-Slot is not metal reinforced.
To Next Page
Loading...
