NMS044 Reference Manual Using SoundLink 20
2.5 Using SoundLink
SoundLink is an IP hosting service that provides secure communication with your remote
noise monitoring systems using a dynamic IP address. This service from Larson Davis
simplifies remote communication with your NMS system. It is an alternative to using a
public, static IP address from your cellular provider, or a viable solution if one is not
available. It works because G4 recognizes SoundLink as a static IP address even though the
cell service connects via a dynamic IP address.
LEARN MORE For more information, contact your Larson Davis representative
or view the SoundLink manual at LarsonDavis.com.
Larson Davis provides complete gateway configuration plus SoundLink configuration
service for new or previously deployed gateways. For previously deployed units without a
public, static IP, the SoundLink configuration service requires that you ship the gateway to
Larson Davis.
For new systems, if you prefer to configure the gateway for SoundLink service yourself,
complete the following steps:
Step 1. Complete the initial gateway setup as shown section 2.3 Connecting the
Gateway to Cellular Service.
Step 2. Complete the SLM setup as shown in section 2.4 Reviewing 831C SLM System
Properties for Use With NMS044.
Step 3. Complete SoundLink setup as shown in the SoundLink manual. The manual is
attached to your SoundLink Plan Details email from Larson Davis. When this
process is complete, your new NMS system is ready for deployment.
Recommended next step:
• Module 3 Installing the NMS System
To Next Page
Loading...
Need help?
General