EasyManua.ls Logo

PCI 56K - Appendix B: Regulatory Information; FCC Part 15 Emissions Statement; FCC Part 68 Statement

PCI 56K
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix B: Regulatory Information 37
Appendix B: Regulatory Information
FCC Part 15 Emissions Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and
can radiate radio frequency and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communi-
cations.
However there is no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause interference to radio and
television reception, which can be determined by turning the equipment
off and on, try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Part 68 Statement
This equipment complies with Part 68 of the FCC rules. The unit bears a
label which contains the FCC registration number and Ringer Equiva-
lence Number (REN). If requested, this information must be provided to
the telephone company.
This equipment uses the following standard jack types for network con-
nection: RJ11C.
This equipment contains an FCC-compliant modular jack. It is designed
to be connected to the telephone network or premises wiring using com-
patible modular plugs and cabling which comply with the requirements of
FCC Part 68 rules.
The Ringer Equivalence Number, or REN, is used to determine the num-
ber of devices which may be connected to the telephone line. An excessive
REN may cause the equipment to not ring in response to an incoming
call. In most areas, the sum of the RENs of all equipment on a line should
not exceed five (5.0).