Peak FCB8N - EXP Mode

PEAK FCB8N: Programmable MIDI foot controller
Page 13 of 16
EXP Mode
The expression pedal can be assigned to any Control Change Number on any MIDI channel for each
individual PATCH. To assign the expression pedal:
1. Select the PATCH you want to assign expression pedal to.
2. Enter to Programming Mode. (Please see Programming Mode Entry section)
3. Press EXP switch, the BANK/PROGRAM display will show the following:
ExP
4. All Programming Menu LED’s will be off and the EXP LED will be flashing.
5. Press and hold the MENU switch.
6. Scroll up and down the sub-menus by pressing NEXT>> to see the next sub-menu or
<<PREV to see previous sub-menu:
E1.CH  E1.CC  dAtA
Once a menu item has been selected, press the ENTER switch to access the value to be
changed. Use the INC+ and DEC- switches to increment and decrement the value.
0 127: Toggles the value between 0 and 127 on each successive press of the INSTANT
ACCESS switch.
E1.CH: MIDI Channel for expression pedal messages.
Range: 0116
E1.CC: Control Change Numbers (CC#) for expression pedal Control Change Messages.
Range: 01127
dAtA: Data display for testing your expression pedal (Input signal checking). If your
expression pedal works with the FCB8N then the BANK/PROGRAM display will
show the pedal position value between 0127
7. To save press the SAVE switch or to exit without saving press the CANCEL switch. The
FCB8N will return to operating mode.