Peak FCB8N - Factory Restore; MIDI Implementation

PEAK FCB8N: Programmable MIDI foot controller
Page 14 of 16
Factory Restore
You can reset the FCB8N to the factory default settings. The data that you saved in the EEPROM memory
will be erased and the unit returned back the factory default settings.
There are two different numbering systems used by various MIDI equipment manufacturers, either 0
 127 or 1  128, 0. The FCB8N can be configured to use either system (for example the POD2.0
uses 1  127, 0).
To restore the factory defaults:
1. Unplug the power from the FCB8N unit.
2. To restore to factory default settings to 12Pr mode:
- Press and hold P4 switch if you want to use 0  127
- Press and hold P3 switch if you want to use 1  127, 0
3. To restore to factory default settings to 4Pr mode:
- Press and hold P8 switch if you want to use 0  127
- Press and hold P7 switch if you want to use 1  127, 0
4. Plug the power into the FCB8N unit.
5. The BANK/PROGRAM display will show the characters below while it is processing a
restore.
6. When the BANK/PROGRAM display indicates that the unit has returned to operating mode,
release the switch.
7. Wait a moment until restore process has completed. The FCB8N will be initialized with the
factory default settings.
MIDI Implementation
MIDI Channels: 1 – 16 Default = 1 (MIDI Channel#1)
Program Change#: 0 – 127 7 Program Change Messages transmitted per PATCH.
(On independent MIDI channels)
Controller#: 0 – 127 8 Control Change Messages transmitted per PATCH.
(On a single MIDI channel)
Control Change Value: 0 – 127 Set value in each controller.
: tr, tAP1,tAP2 - Momentary and Toggle control of the value
- Value 0-63 = OFF (momentary off value = 0)
- Value 64-127 = ON (momentary on value = 127)