Peak FCB8N - SETUP MODE AND PATCH PROGRAMMING; Programming Mode Entry; Setup Mode

PEAK FCB8N: Programmable MIDI foot controller
Page 8 of 16
SETUP MODE AND PATCH PROGRAMMING
Programming Mode Entry
On power-up the FC8BN defaults to operating mode. To change to edit mode:
1. Select the PATCH that you want to configure by using the BANK and PATCH switchs.
2. Press both BANK UP and BANK DOWN switches together and hold on until the
BANK/PROGRAM display shows the following:
PROG
(The BANK/PROGRAM display as shown above means “Programming Mode” )
3. Release the BANK UP and BANK DOWN switches.
4. The BANK/PROGRAM display and the active LED will be flashing.
5. Flashing LED’s indicate programming menu functions that are available for editing. Refer to
the text below the flashing LED’s.
6. Press the associated switch to enter the required programming menu.
Programming menus are: EDIT, COPY, SETUP and EXP. You can exit from programming
mode and return to operating mode by pressing the CANCEL switch.
Setup Mode
Configure the FCB8N to operate in 4Pr mode or 12Pr mode or adjust LED display contrast:
1. Enter Programming Mode. (Please see Programming Mode Entry section)
2. When in Programming Mode press the SETUP switch, the BANK/PROGRAM display will
show the following:
StUP
3. All Programming Menu LED’s will be off and the SETUP LED will be flashing. This means you
are in Setup mode. To see associated sub-menus please press and hold MENU switch.
4. Scroll up and down the sub-menus by pressing NEXT>> to see the next sub-menu or
<<PREV to see previous sub-menu. This mode has 2 sub-menus:
4.1) PATCH setup: the BANK/PROGRAM display will show the following:
PrSt