Peak FCB8N - Page 9

PEAK FCB8N: Programmable MIDI foot controller
Page 9 of 16
To change the PATCH setup, press the INC+ or DEC- switches. The PATCH setup will be
changed between 4Pr mode and 12Pr mode. The BANK/PROGRAM display will show the
following:
4.Pr 12.Pr
4.2) LED display contrast adjustment: the BANK/PROGRAM display will show the
following:
Cont.
Adjust the BANK/PROGRAM display contrast by pressing INC+ or DEC- switches. The
contrast has a range of between 0 (minimum) and 15 (maximum).
4.3) Global CC assignment: the BANK/PROGRAM display will show the following:
A1.CH  A1.CC 
A2.CH  A2.CC 
A3.CH  A3.CC 
A4.CH  A4.CC 
A5.CH  A5.CC 
A6.CH  A6.CC 
A7.CH  A7.CC 
A8.CH  A8.CC
Once a global CC has been selected, press the ENTER switch to access the value to be
changed. Use the INC+ and DEC- switches to increment and decrement the value.
A1.CH: MIDI Channel for 1
st
Global Control Change Message. Range: 0116
A1.CC: Control Change Number (CC#) for 1
st
Global Control Change Message.
Range: 01127
A2.CH: MIDI Channel for 2
nd
Global Control Change Message. Range: 0116
A2.CC: Control Change Number (CC#) for 2
nd
Global Control Change Message.
Range: 01127
A3.CH: MIDI Channel for 3
rd
Global Control Change Message. Range: 0116
A3.CC: Control Change Number (CC#) for 3
rd
Global Control Change Message.
Range: 01127
A4.CH: MIDI Channel for 4
th
Global Control Change Message. Range: 0116
A4.CC: Control Change Number (CC#) for 4
th
Global Control Change Message.
Range: 01127