Peak FCB8N - Edit Mode

PEAK FCB8N: Programmable MIDI foot controller
Page 10 of 16
A5.CH: MIDI Channel for 5
th
Global Control Change Message. Range: 0116
A5.CC: Control Change Number (CC#) for 5
th
Global Control Change Message.
Range: 01127
A6.CH: MIDI Channel for 6
th
Global Control Change Message. Range: 0116
A6.CC: Control Change Number (CC#) for 6
th
Global Control Change Message.
Range: 01127
A7.CH: MIDI Channel for 7
th
Global Control Change Message. Range: 0116
A7.CC: Control Change Number (CC#) for 7
th
Global Control Change Message.
Range: 01127
A8.CH: MIDI Channel for 8
th
Global Control Change Message. Range: 0116
A8.CC: Control Change Number (CC#) for 8
th
Global Control Change Message.
Range: 01127
5. To save, press the SAVE switch, or to exit without saving press the CANCEL switch. The
FCB8N will return to operating mode.
Edit Mode
On power-up the FC8BN defaults to operating mode. To change to edit mode:
1. Select the PATCH you want to edit.
2. Enter Programming Mode. (Please see Programming Mode Entry section)
3. Press the EDIT switch, the BANK/PROGRAM display will show the following:
Edit
4. All Programming Menu LED’s will be off and the EDIT LED will be flashing. This means you
are in Edit mode. To see associated sub-menus please press and hold MENU switch.
5. Scroll up and down the sub-menus by pressing NEXT>> to see the next sub-menu or
<<PREV to see previous sub-menu.
P1.CH  P1.PC 
P2.CH  P2.PC 
P3.CH  P3.PC 
CC.CH 
C1.CC  C1.dt 
C2.CC  C2.dt 
C3.CC  C3.dt 
C4.CC  C4.dt 
C5.CC  C5.dt 