PEAK FCB8N: Programmable MIDI foot controller
Page 16 of 16
MIDI Cable Support
The FCB8N is a standard MIDI foot controller that can be connected to any MIDI equipment via a
standard 5 pin MIDI cable.
Phantom power into the FCB8N unit via a 7 pin midi cable requires pins 6 and 7 for the power supply.
The polarity is not important.
Phantom power into the FCB8N unit via a 5 pin midi cable requires pins 2 (ground) and 3 (positive) for
the power supply. NOTE: A PCB Jumper must be moved to enable this.
Please read your MIDI device’s instructions before enabling the phantom power.
TIP
In 4Pr Mode, the C1 button to C8 button are instance access buttons. If one of those buttons has
pressed, the selected preset button (P1 button – P4 button) led will be flashing. This means the instance
access data is changed. You can press the flashing led button for 3 seconds, the selected preset will be
replaced with new instance access data to the memory.
To Previous Page
Loading...
