Commissioning
13
UM-NM30LA-MS Gas Generator
UM –NM30LA-MS
Operator Training
The NM30LA-MS Laboratory Gas Generator is designed specifically to minimize operator
involvement. Given that the generator is installed as described in earlier sections and is
serviced in accordance with the following maintenance recommendations then it should
simply be a matter of turning the generator on. The generator will automatically produce
the factory default flow and pressure noted below.
NITROGEN OUTLET 30 litres per min (ATP) 100 PSI.G (680kPa)
Should the demand for gas be less than the rated flow then the generator will
automatically regulate the internal pressure and cycle of the compressors as required.
This should be all the input your generator requires from you, the only additional tasks
required are,
If at any time the generator begins to emit excessive noise or vibration, then it should be
switched off and you should contact your local representative or the factory as soon as
possible.
Please ensure that both the drain ports at the rear of the generator are led to a suitable
connection or container.
It should be noted that the generator will liberate considerable amounts of water from
these ports (approx. 1-2 litres weekly). If a container is used it should be emptied at
regular intervals.
Ensure that the generator is serviced in accordance with the following maintenance
recommendations.
To Next Page
Loading...