PeakTech 5201 User Manual

21
7. Battery Replacement
If the sign “BAT” appears on the LCD display, it indicates that the
battery should be replaced.
Remove the back cover and open the battery compartment.
Replace the exhausted battery with new battery.
Batteries, which are used up dispose duly. Used up batteries are
hazardous and must be given in the - for this being supposed -
collective container.
NOTE
1. Keep the instrument dry.
2. Keep the probes clean.
3. Keep the instrument and battery out of reach of infant and
child.
4. When the symbol ” ” appears, the battery is low and
should be replaced immediately. When you install battery,
ensure the polarity connections are correct. If you will not use
the instrument in a long period of time, remove the battery.

PeakTech 5201 Specifications

General

Display	LCD with automatic backlight
Resolution:	0.1
Measurement Range	0.0 ~ 100.0
Penetration depth	20 ~ 40 mm
DATA-HOLD	Holds measurement value in display
Low Battery Indication	Symbol “ “ shown in the display
Auto Power Off	After 10 Minutes
Power Supply	3 x 1, 5V AAA (UM-4)
Operating Environment	0°C ~ 50°C; <80% RH
Storage Environment	-10°C ~ 50°C; <70% RH

Weight and Dimensions

Size (WxHxD)	60 x 245 x 27mm
Weight	220g