IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using electric products, basic cautions should always be followed, including the following.
Read all safety and operating instructions before using this product.
All safety and operating instructions should be retained for future reference.
Obey all cautions in the operating instructions and on the back of the unit.
All operating instructions should be followed.
2.
3.
5.
6.
This product should not be used near water,
i.e.,
a bathtub, sink, swimming pool, wet basement, etc.
This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a
wall or placed in a built-in enclosure that will impede the flow of cooling air.
This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier.
Connect only to a power supply of the type marked on the unit adjacent to the power supply cord.
7.
8.
9.
Ne
ver break off
the ground pin on the
Hazard and Grounding.”
power
suPPlY
cord. For more information on
grounding,
write for our free booklet “Shock
10.
Power supply cords should always be handled carefully. Never walk or place equipment on power
suppl
cords for cuts or signs of stress, especially at the plug and the point where the cord exits the unit.
y cords. Periodically
check
11.
The power supply cord should be unplugged when the unit is to be unused for long periods of time.
If this product is to be mounted in an equipment rack, rear support should be provided.
12.
13.
Metal parts can be cleaned with a damp rag. The vinyl covering
used on some units can be cleaned
based household cleaner if necessary. Disconnect unit from power supply before cleaning.
with a damp rag or an ammonia-
14.
Care should be
openings.
taken so that objects do not fall and liquids are not spilled into the unit through the ventilation holes or any other
15.
This unit should be checked by a qualified service technician if:
a.
The power supply cord or plug has been damaged.
b.
Anything has fallen or been spilled into the unit.
C.
The unit does not operate correctly.
d.
The unit has been dropped or the enclosure damaged.
16.
The user should not attempt to service this equipment. All service work should be done by a qualified service technician.
This product should be used only with a cart or stand that is recommended by Peavey Electronics.
Exposure to extremely high noise levels may cause a permanent hearing loss. Indiv
iduals vary
considerably in susceptibility
to noise
induced hearing loss, but nearly everyone will lose some hearing if exposed to
sufficiently intense noise for a sufficient time.
17.
18.
U.S. Government
exposures.
Occupational Safety and
Health Administration (OSHA) has specified the following permissible noise level
Duration Per Day In Hours
8
6
Sound Level
dBA,
90
92
95
97
100
102
105
110
115
Slow R.esponse
4
3
2
1 l/2
l/2
l/4 or less
According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors in
the ear canals or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss if
exposure is in excess of the limits as set forth above. To ensure against potentially dangerous exposure to high sound pressure levels, it is
recommended that all persons exposed to equipment capable of producing high sound pressure levels such as this amplification system be
protected by hearing protectors while this unit is in operation.
SAVE THESE INSTRUCTIONS!
15
To Next Page
Loading...
