SPECIFICATIONS
Output Power: (typical value)
(@
120 VAC, 60
Hz)
Stereo mode, both channels driven:
2 ohms,
1
kHz, 1% THD: 900 W RMS per channel
4 ohms,
I
kHz, 1% THD: 600 W RMS per channel
8 ohms,
1
kHz, 1% THD: 350 W RMS per channel
Bridge mode. mono:
4 ohms, 1 kHz, 1% THD: 1800 W RMS
8 ohms, 1 kHz, 1% THD: 1200 W RMS
Rated Output Power:
(@
120 VAC, 60 Hz)
Stereo mode, both channels driven:
4 ohms, 20 Hz to 20 kHz, 0.04% THD: 550 W RMS
per channel
8 ohms, 20 Hz to 20 kHz, 0.04% THD: 300 W RMS
per channel
Power Bandwidth: (typical value)
Stereo mode, both channels driven
@
rated power, 4 ohms, ~0.1% THD:
10
Hz to 40 kHz
Slew Rate: (typical value)
Stereo mode, each channel: 40 volts per
pSec
Bridge mode, mono: 80 volts per
ySec
Total Harmonic Distortion: (typical)
Stereo mode, both channels driven:
20 Hz to 20 kHz, 4 ohm rated load: Less than 0.04%
Input Sensitivity
&
Impedance:
Input attenuator set
@
FCW:
@
rated output power, 4 ohms:
1
.O
V RMS (0 dBV),
20 k ohms
(+33
dB)
Frequency Response: (typical value)
Stereo mode, both channels driven:
+0,-l
dB,
1
W RMS, 4 ohms:
IO
Hz to 40 kHz
+O,
-0.2
dB
@
rated output, 4 ohms: 20 Hz to 20 kHz
Damping Factor: (typical value)
Stereo mode, 8 ohms, I kHz: Greater than 300
Hum
&
Noise:
Stereo mode, below rated power, 4 ohms: 100 dB,
unweighted
Power Consumption:
Stereo mode, both channels driven:
@
rated output power, 4 ohms: 13 A
@
120 V AC,
6.8 A
@
230 V AC
Cooling System:
Dual 2 speed fans
DDTTM
Compression System:
Switchable with LED
Dimensions
&
Weight:
Height: 3.50” (8.9 cm)
Width:
19”
(48.3 cm)
Depth 17” (43.2 cm)
Weight 35 lbs. (15.9 kg)
Two Rack Space, Class BG, Dual Rail Design With
NSSER Topology
(NSSER: non-saturating series single emitter resistor)
Patent Pending.
Due to our efforts
for
constant improvements,
,features and specifications listed herein are subject
to
change without notice.
9
To Next Page
Loading...
