3
SAVE THESE INSTRUCTIONS
1
Save the carton and packing materials!
Should you ever need to ship the unit,
use only the original factory packing.
For replacement packaging, call Peavey
Customer Service Department directly.
2
Read all documentation before operat-
ing your equipment. Retain all docu-
mentation for future reference.
3
Follow all instructions printed on
unit chassis for proper operation.
4
Never hold a power switch or circuit
breaker in the "ON" position if it
won’t stay there by itself!
5
Do not use the unit if the electrical
power cord is frayed or broken.
The power supply cords should be
routed so that they are not likely to
be walked on or pinched by items
placed upon or against them.
6
Always operate the unit with the AC
ground wire connected to the electri-
cal system ground. Precautions should
be taken so that the means of ground-
ing of a piece of equipment is not
defeated.
7
Damage caused by connection to
improper AC voltage is not covered by
any warranty. Mains voltage must be
correct and the same as that printed on
the rear of the unit.
8
Do not ground any hot (red) terminal.
Never connect a hot (red) output to ground
or to another hot (red) output!
9
Power down and disconnect units from
mains voltage before making connec-
tions.
10
Do not drive the inputs with a signal
level greater than that required to
enable equipment to reach full out-
put.
11
Do not run the output of any amplifier
channel back into another channel’s
input.
Do not parallel- or series-connect
an amplifier output with any other
amplifier output.
Peavey is not responsible for damage
to loudspeakers for any reason.
12
Do not connect the inputs or out-
puts of amplifiers to any other volt-
age source such as a battery, mains
source, or power supply, regardless
of whether the amplifier is turned
on or off.
13
Connecting amplifier outputs to oscil-
loscopes or other test equipment while
the amplifier is in bridged mono mode
may damage both the amplifier and test
equipment!
14
Do not spill water or other liquids
into or on the unit, or operate the unit
while standing in liquid.
15
Do not block fan intake or exhaust
ports.
Do not operate equipment on a sur-
face or in an environment which
may impede the normal flow of air
around the unit, such as a bed, rug,
weathersheet, carpet or completely
enclosed rack.
16
If the unit is used in an extremely
dusty or smoky environment the
unit should be periodically blown
free of foreign matter.
17
Do not use the unit near stoves,
heat registers, radiators or other
heat-producing devices.
18
The equipment power cord should be
unplugged from the outlet when left
unused for a long period of time.
Service Information
Do not remove the cover!
Removing the cover will expose you
to potentially dangerous voltages.
There are no user-serviceable parts
inside.
Equipment should be serviced by
qualified service personnel when:
A. The power supply cord or the plug has
been damaged.
B. The equipment has been exposed to
rain.
C. The equipment does not appear to
operate normally or exhibits a marked
change in performance.
D. The equipment has been dropped or
the enclosure damaged.
To obtain service:
contact your nearest Peavey Service
Center, Distributor, Dealer or con-
tact Peavey at 601.483.5365 USA or
visit www.peavey.com for additional
information, email techserve@peavey.
com
To Next Page
Loading...
