EasyManua.ls Logo

Peavey PV 1500 - Product Specifications; Rated Output Power and Impedance; Distortion and Frequency Response; Feature Set and Topology

Peavey PV 1500
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
Specifications PV
®
900 PV
®
1500 PV
®
2600
RATED OUTPUT POWER:
Stereo mode (EIA both channels driven)
4 Ohms EIA, 1 kHz, 1% THD 300 W RMS/chan 500 W RMS/chan 900 W RMS/chan
8 Ohms EIA, 1 kHz, 1% THD 180 W RMS/chan 300 W RMS/chan 550 W RMS/chan
Bridge mode, mono
8 Ohms EIA, 1 kHz, 1% THD 600 W RMS 1000 W RMS 1800 W RMS
HUM & NOISE:
Stereo mode, below rated output power, 4 ohms 100 dB, unweighted 100 dB, unweighted 100 dB, unweighted
DISTORTION:
SMPTE-IM Less than 0.01% Less than 0.01% Less than 0.01%
INPUT SENSITIVITY & IMPEDANCE:
@ rated output power, 4 ohms 0.87 V RMS(-1.2 dBV) 1.12 V RMS(+1dBV) 1.5 V RMS(+3.5 dBV)
Balanced, TRS 1/4” phone jack 10 K Ohms per leg 10 K Ohms per leg 10 K Ohms per leg
Balanced, XLR (pin 2 positive) 10 K Ohms per leg 10 K Ohms per leg 10 K Ohms per leg
Overall system gain per channel 40X (+32 dB) 40X (+32 dB) 40X (+32 dB)
DISTORTION: (THD, typical value)
Stereo mode, both channels driven, 4 Ohms
20 Hz to 20 kHz, 10 dB below rated power Less than 0.03% Less than 0.03% Less than 0.03%
20 Hz to 2 kHz, at full rated power Less than 0.03% Less than 0.03% Less than 0.03%
FREQUENCY RESPONSE:
Stereo mode, both channels driven
+0, -1 dB @ 1 W RMS, 4 ohms 20 Hz to 20 kHz 20 Hz to 20 kHz 20 Hz to 20 kHz
+0, -3 dB @ rated output, 4 ohms 5 Hz to 50 kHz 5 Hz to 50 kHz 5 Hz to 50 kHz
DAMPING FACTOR: (Typical value)
Stereo mode, both channels driven
8 Ohms, 1 kHz Greater than 300 Greater than 300 Greater than 300
POWER CONSUMPTION:
Stereo mode, both channels driven
@ 1/8 rated output power, 4 Ohms 5.0 ARMS @ 120 VAC 7.0 ARMS @ 120 VAC 7.0 ARMS @ 120 VAC
TOPOLOGY: Class AB Class AB Class H
WEIGHT: 40 lbs (18.2 kg) 45 lbs (20.5 kg) 49 lbs (22.3 kg)
FEATURE SET: All Models (++ indicates each channel)
DDT
COMPRESSION ++: Automatic, switchable with LED indicator
COOLING SYSTEM: Two-speed DC fan, air flow back to front
LOW CUT FILTER ++: -3 dB @ 40 Hz, 12 dB per octave
CROSSOVER ++: 150 Hz, 4-pole Linkwitz-Riley approximation
INPUTS ++: Electronic balanced; Barrier Strip, XLR, TRS 1/4" (6.3 mm)
CROSSOVER OUTPUTS ++: Low/Thru and High, TS 1/4" (6.3 mm)
AMPLIFIER OUTPUTS: Speakons for Chan A, Chan B and Bridge; Binding Posts
LED INDICATORS ++: Red, DDT/clipping; Yellow, signal; Green, power
AMP PROTECTION: Full short circuit, open circuit; over-temp thermal; RF; stable into any load
LOAD PROTECTION: Turn on/off muting, DC (triac crowbar), low-cut filter
MAINS VOLTAGES AVAILABLE 100, 120, 230, 240 VAC, 50-60 Hz
DIMENSIONS: Height: 3.5” (8.9 cm), Width: 19" (48.3 cm), Depth: 15.5" (38.0 cm)
Specifications subject to change without notice

Other manuals for Peavey PV 1500

Related product manuals