Peavey VYPYR PRO - Output Menu

OUTPUT MENU
When this menu is selected, the main LCD screen will display the status of the Boost feature, as well as the
MIDI program message to be sent via MIDI for that particular preset. Using the OUTER BANK WHEEL will
toggle between Boost on/o. e INNER KNOB controls what MIDI program# message is sent via MIDI.
•P1—Boost Level. No preset Boost level here on the Vypyr Pro, you can program it per preset! Here
you can set the boost for anything in between a 2.65dB and 9dB boost.
•P2—Looper Level. Purchasing the optional Sanpera Pro footcontroller enables you to use the onboard
multi-overdubbing Looper. Each time you add a loop, the level of that loop’s playback can be adjusted
here to anything between -18dB to +6.6dB.
•P3—Presence control. e Presence control can be set per preset on the Vypyr Pro! is controls the
high end damping factor of the power amp, adding high end to the overall signal.
•P4—Resonance control. e Resonance control operates in a similar fashion to the Presence control,
but instead of high end it controls low end. e Resonance control will add the low end thump you
desire when using high gain palm muting techniques.
•P5—Master Volume. is is an incredibly handy feature to have in a modeling amp. Frequently, vol-
ume levels between presets can be tricky to get exactly how you want them, since stage level can vary
so much in relation to practice level. Typically, the remedy for this would be to adjust the POST GAIN
control of the amplier model. However, this is not ideal because adjusting the POST GAIN control
also aects the sound of the amplier model, particularly in lower power models. By using this Master
Volume control, the volume level between presets can be adjusted without compromising the tone of
the amplier model!
NOTE: In Deep Edit Mode, the Tap Tempo cannot be used as the CANCEL button. To exit the Deep Edit
Menu, simply tap the Delay/Reverb Edit button.
Deep Edit Menu cont.
Product Specifications
Vypyr Pro 100 - General Specications
Rated Power & Load:
(10% THD, 1kHz, 120V AC line)
100W(rms) into 16 Ohms
Power Consumption (1/8th Power Output):
42W @ 50/60Hz, 100-120V AC
42W @ 50/60Hz, 220-240V AC
Dimensions & Weight
20.0”H x 23.0”W x 10.0”D
38.0 lbs.