Peavey VYPYR PRO - IMPORTANT SAFETY INSTRUCTIONS; General Safety Precautions; Installation and Electrical Safety; Usage, Maintenance, and Noise Exposure

Front Panel
0
7
8
1
2
3
4
5
6
10
11
9
12
13
master
User Presets
shift level feedback
delay reverb
aux in phones
push to
select
HOLD for
MAIN menu
bank
(outer)
preset
(inner)
push to edit
room size level
tap/
cancel
HOLD
for tuner
HOLD
for adv. edit
onon
del/rev
edit
premodel 4model 3model 2model 1 low mid high post
mode
select
P1 P2 P3 P4 P5
input
PRO-100
VYPYR
®
powerstandby
Instrument Input
Plug in your instrument here.
Model Bay Displays
In “Mode Select” mode displays the available model types (Instrument {model bay 1 only}, Amp, Stomp Box
and Eects). In normal mode displays the selected models.
Mode Select Button
Allows the user to switch into Mode Select mode. Holding the Mode Select Button down for 2 seconds chang-
es the Model Select Knobs to Signal Chain Select Mode. In this mode, you can change the order that the mod-
els are in, simply by turning the knobs. is is particularly handy when you have forgotten to add a certain
model in model bay 1. With Signal Chain Select Mode, you would then move the other 3 models to the right,
leaving Model Bay 1 empty and ready for you to add the model you wish to add.
Model Select Knobs
Allows user to scroll through Modules and Modes.
Tap Tempo Control/Tuner Selector/Cancel
Tapping this button sets the delay time for the Delay eect. Holding this button down activates the tuner func-
tion. In most instances, this button can be used to cancel out of a menu.
Delay/Reverb Edit Button
Tapping this button once activates the Delay/Reverb Quick Edit Menu. Pressing and holding this button acti-
vates the Deep Edit Menu, which is described in detail later in this owner’s manual.
Delay Parameter Adjustment Knobs
When in Delay Edit Mode, these knobs adjust Shi, Delay Level and Feedback.
Reverb Parameter Adjustment Knobs
When in Reverb Edit Mode, these knobs adjust Room Size and Level.
Parameter Adjustment Knobs
ese knobs adjust model parameters. Amp parameters are listed because they are the same on each amp.
Other model parameters are shown on the screen as you edit.
1 2
3
4 5 7 8 11 12 14
6 9 10 13 15 16
1
2
3
4
5
6
7
8
9