PEERLESS Mounts PRG UNV User Manual

ISSUED: 02-13-07 SHEET #: 055-9485-1
Visit the Peerless Web Site at www.peerlessmounts.com
1 of 33
For customer care call 1-800-865-2112 or 708-865-8870.
Read instruction sheet before you start installation and assembly.
Maximum Load Capacity: 50 lb (23 kg)
Installation and Assembly - PRG- Precision Gear
Projector Mount
Models: PRG UNV, PRG UNV-W,
PRG UNV-S
R
This product is intended for use with UL
Listed products and must be installed by a
qualified professional installer.
• Installer must verify that the supporting surface will
safely support the combined load of the equipment and
all attached hardware and components.
WARNING
PRG-UNV
PROJECTOR
MOUNT
Table of Contents
Parts List .................................................................................................................................................................... 2
Installation to Extension Columns / Ceiling Plate........................................................................................................ 3
Installation to Wood Joist Ceilings .............................................................................................................................. 4
Installation to Concrete Ceilings.................................................................................................................................. 5
Installation to Threaded Rods...................................................................................................................................... 6
Attaching Adapter Plate to Projector........................................................................................................................... 7
Projector Alignment .................................................................................................................................................... 9
Accessories.........................................................................................................................................................10, 11
Tools Needed for Assembly
• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
• 1/4" bit for concrete surface
• 5/32" bit for wood studs
• open end wrench
• level
• It is the responsibility of the installer to ensure that the
projector is properly ventilated. Feet of channels are
used to raise the mount off the projector surface.
CAUTION

PEERLESS Mounts PRG UNV Specifications

General

Product Type	Projector Mount
Mounting Pattern	Universal
Color	Black
Mount Type	Ceiling
Material	Steel
Weight Capacity	50 lbs
Tilt	+/- 20°
Swivel	360 degrees
Compatibility	Most projectors

Summary

Tools Needed for Assembly

Parts List

Installation Procedures

Installation to Extension Column / Ceiling Plate

Connects mount to ceiling plates or extension columns.

Installation To Wood Joist Ceilings

Mounts projector to wooden ceiling joists using screws.

Installation to Concrete Ceilings

Fastens mount to concrete ceilings using anchors.

Installation to Threaded Rod

Attaches mount to threaded rods with locknuts.

Attaching Adapter Plate to Projector

Projector Alignment

Adjusting Yaw (Swivel)

Rotates projector horizontally for optimal viewing angle.

Adjusting Pitch and Roll

Tilts projector forward/backward and side-to-side.

Securing Adjustments

Locks pitch and roll settings using tamper-resistant screws.