FOR YOUR SAFETY READ BEFORE OPERATING
I WARNING: If do follow these instructions a fire or explosion result
I
you
not
exactly, may
causing property damage, personal injury, or toss of life. I
A. This appliance is equipped with an ignition device • If you cannot reach your gas supplier, call the fire
which automatically lights the pilot. Do not try to department.
light the pilot by hand.
g.
BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO OF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch;
do not use any phone in your building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
supplier's instructions.
C,
Use only your hand to slide the gas control switch,
Never use tools. If the switch will not slide by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may result in a
fire or explosion.
D,
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the control system and any gas control which has
been under water,
_ OPERATING INSTRUCTIONS
1. STOP! Read the safety information above on this
label.
5. If the gas valve is not visible, remove control access
panel.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
/--GAS CONTROL
SWITCH
6. If the gas control switch is not in the "OFF" position,
slide the switch to "OFF".
7. Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow "B" in the safety
information above this label. If you don't smell gas,
go to the next step.
8. Slide the gas control switch to "ON".
9. Replace control access panel, if applicable.
10. Turn on all electric power to the appliance.
11. Set the thermostat to desired setting.
12. If the appliance will not operate, follow the
instructions "To Turn Off Gas To Appliance" and call
your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE _
1. Set the thermostat to lowest setting. 4. Slide the gas control switch to "OFF".
2. Turn off all electric power to the appliance if service 5. Replace control access panel, if applicable.
is to be performed.
3. If the gas valve is not visible, remove the control
access panel. SV95011SV9601 9318
Figure 25: Operating Instructions
22
To Next Page
Loading...
