I[,-']t-'; • ,'_ B • "]
FOR YOUR SAFETY READ BEFORE LIGHTING
I
A. This •ppU•nce has a pilotwhich must be lighted by
hand. When lighting the pilot, follow these instruc-
tions exactly.
B. BEFORE OPERATING smell •round the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance
• Do not touch any electric switch;
do not u•e any phone In your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppller's
instructions.
• If you cannot reach your gas supplier, call the
fire department.
C.
Use only your hand to push in or turn the gas con-
trol knob. Never use tools. If the knob will not push
In or turn by hand, don't try to repair it, call a quali-
fied service technician. Force or attempted repair
may result in a fire or explosion.
D,
Do not use this appliance if any pert has been under
water. Immediately cell a qualified service techni-
cian to inspect the appliance and to replace any part
of the control system and any gas control which
has been under water.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above on this
label.
2. Set the thermostat to lowest setting.
3. Turn off •11 electric power to the appllence.
4. If the gas valve is not visible, remove control aceess
panel.
5. If the gas control knob is not in the "OFF" position,
turn the knob clockwise _ to "OFF."
Gas Control Knob F'- RED RESET BUTTON
(shown in _OFF" /
position) -_ /
J*o_ id 41
A
. _1 INLET
6. Walt five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP; Follow "B" in the safety information
above on this label. If you don't smell gas, go to the
next step.
7. Remove the pilot access panel, if supplied, located
below and behind the gas valve directly above burn-
er tubes
8.
Find pilot--follow metal tube F_
from gas valve. The pilot is
between two burner tubes.
Pilot Burner
9. Turn the gas control knob counterclockwise #"% to
"PILOT."
10. Push In red reset button all the way and hold in.
Immediately fight the pilot with • match. Continue to
hold the reset button in for •bout one (1) minute
after the pilot is lit. Release button and it will pop
back up. Pilot should remain llt. If it goes out, repeat
steps 5 through 10.
• If button does not pop up when released, stop
and immediately call your service tachnici•n or
gas supplier.
• If the pllet will not stay lit after several tries,
turn the gas control knob to "OFF" and cell
your service technician or gas supplier.
11. Replace pilot access panel, if applicable.
12. Turn gas control knob counterclockwise
to "ON."
13. Replace control access panel, if applicable.
14. Turn on all electric power to the •ppllance.
15. Set thermostat to desired setting.
_TO TURN OFF GAS TO APPLIANCE _
1. Set the thermostat to lowest setting.
2. Tum off all electric power to the appliance if service
is to be performed.
3. If the gas valve is not visible, remove control access
panel.
4. Turn the gas control knob clockwise (_ to "OFF."
5. Replace control access panel, if applicable.
H24V VR8200 9177R
Figure 26: Lighting Instructions
23
To Next Page
Loading...
