What to do if "AI Error" appears on the screen of Pegasus Industrial Equipment?
If the Pegasus Industrial Equipment displays "AI Error" on the screen, first check the gears for dust accumulation. Clean them to ensure the motor runs smoothly. If the gears don't engage properly, loosen screws 1 and remove any backlash or play so they engage correctly, then tighten screws 1.
Why does my Pegasus Industrial Equipment show a garbled display or error messages?
If the Pegasus Industrial Equipment shows a garbled display or "Error 1", "Error 2", or "Error 3", or if the entered data changes unexpectedly, turn off the power. Check that the two earth wires are correctly connected. Then, turn the power back on. If the data has changed, re-enter the correct data.
How to troubleshoot if the Al device of Pegasus Industrial Equipment is not turned on?
If the Al device of your Pegasus Industrial Equipment is not turning on, ensure the power relay cord is correctly connected to the controller, and verify that the cord matches the supply voltage. Also, check the wiring inside the power switch and connect wires of the same colors. Finally, inspect the controller's fuse and replace it if broken.
What to do if the Al motor keeps running on my Pegasus Industrial Equipment?
If the motor for the Al device of your Pegasus Industrial Equipment keeps running while the power is on, ensure the three sensors on the Al motor can detect the lever by properly positioning the lever. Also, make sure that even when the power is off, the differential lever is aligned with at least one of the three sensors. Check that the relay cords for the three sensors are correctly connected, matching the same colors.
General| Brand | Pegasus |
|---|---|
| Model | W500 Series |
| Category | Sewing Machine |
| Language | English |
To Next Page
