What to do if I cannot close the door of my Pelgrim Dishwasher?
If you cannot close the door of your Pelgrim dishwasher: * Make sure that the baskets are correctly positioned horizontally. * If the door lock doesn't click, open the door, press and hold Combi drying until the display counts down, wait until it ends, and then close the door again to see if it locks.
Why my Pelgrim GVWC290L/P03 Dishwasher does not start?
If your Pelgrim dishwasher isn't starting, there are several potential causes: * Ensure the start button has been pressed, and the display is counting down. * Verify the door is completely closed. * If you opened the dishwasher mid-cycle, close the door and wait for the program to resume. * Check that the door lock clicks into place; if not, open the door, press and hold the Combi drying button until the display counts down, then close the door again. * If the Delayed start option is active, press and hold the button for three seconds to cancel it. * Confirm that the plug is securely in the wall socket. * Check for tripped fuses or circuit breakers.
What to do if my Pelgrim GVWC290L/P03 Dishwasher salt compartment is empty?
If the salt compartment is empty in your Pelgrim dishwasher, top up with salt.
What to do if my Pelgrim Dishwasher door won't close?
If you cannot close the door of your Pelgrim Dishwasher: * Check that the baskets are correctly positioned horizontally. * If the door lock does not click into place and lock, open the door. Press and hold Combi drying until the display starts counting down. Wait until the countdown ends (60 seconds). Close the door. Check that the door lock clicks into place and locks.
What to do if my Pelgrim GVWC290L/P03 has a kink in drainage hose?
If your Pelgrim dishwasher has a kink in the drainage hose, check that the hose is free from kinks and sharp bends.
What to do if my Pelgrim GVWC290L/P03 Dishwasher has some foodstuffs causing spots on stainless steel?
If some foodstuffs are causing spots on the stainless steel in your Pelgrim dishwasher, rinse off these types of foodstuffs if not starting the dishwasher immediately. Consider using 1h 65° with the Speed wash option.
How to get rid of bad odour in Pelgrim GVWC290L/P03 Dishwasher?
If there's a bad odor in your Pelgrim dishwasher: * Clean around the seals and in corners with a washing-up brush and low foaming cleaner. * If you've been using low-temperature programs for a long time, run a high-temperature program once or twice a month.
Why are there spots or films on the dishes in my Pelgrim GVWC290L/P03?
If you notice spots or films on dishes from your Pelgrim dishwasher, check these: * Adjust the rinse aid dosage setting. * If using all-in-one detergents with the TAB setting activated, switch to separate detergents or deactivate the TAB setting and add salt and rinse aid. * Ensure the salt compartment is full.
How to fix Pelgrim GVWC290L/P03 Dishwasher if the dishes are not dry enough?
If your Pelgrim dishwasher leaves dishes not dry enough, consider the following: * Activate the Combi drying option. * Ensure the dishwasher is fully loaded. * Top up the rinse aid or increase its dosage setting. * If using all-in-one detergents with the TAB setting activated, switch detergents or deactivate the TAB setting and add salt and separate rinse aid.
What to do if water remains in my Pelgrim GVWC290L/P03 Dishwasher?
If water remains in your Pelgrim dishwasher, it could be due to several reasons: * The filters might be clogged, so clean the coarse and fine filters. * The filters might not be fitted correctly, so check their placement. * There might be debris in the drainage pump, so clean the drainage pump.
General| Type | Freestanding |
|---|---|
| Number of programs | 5 |
| Noise level | 49 dB |
| Number of place settings | 13 |
| Energy Efficiency Class | A++ |
| Capacity | 13 place settings |
| Annual Water Consumption | 2520 L |
| Drying Class | A |
| Delay Start | Yes |
| Half Load Option | Yes |
| Child Lock | No |
| Dimensions (HxWxD) | 85 x 60 x 60 cm |
To Next Page