pellenc 250 - Start-Up; Fitting the Battery on the Harness; Switching the Battery on and off

To Next Page

To Previous Page

PELLENC BATTERY 250

56_158890-D

4. START-UP

4.1. FITTING THE BATTERY ON THE HARNESS

Note

The following procedure is valid for the purchase of a single battery delivered not fitted on the harness.

1. Fitting the battery (1) on the harness (2).

2. Install and tighten the 4 screws (3).

4.2. SWITCHING THE BATTERY ON AND OFF

Powering on

1. If the HMI display is off, press one of the 2 On/Off buttons to wake up the battery from standby.

Note

The HMI display shows the remaining battery capacity and the power LED remains off when the device

is switched off.

2. Press one of the 2 On/Off battery buttons.

Powering off

• Press one of the 2 On/Off battery buttons.