PELLENC BATTERY 250
56_158890-D
6. When the gauge display (6) flashes, the battery
is charging. The charging is finished when the
message appears on the gauge display (6) and
the charger LED (2) is solid green.
Once the battery is charged, first disconnect the
charging cord (3) from the battery and then the
mains plug from the charger (1).
Note
After a long storage period (new battery, winter storage etc.), when you disconnect the charger, the charge
level indicator may display a value of less than 99%. This is a normal phenomenon which can reoccur for up
to 5 charge cycles with normal use between each charge.
4.4. HMI DISPLAY
The battery is equipped with an HMI display that shows the remaining capacity of the battery. The capacity is
expressed as a percentage.
• If the display shows 99%, the battery is fully charged.
• If the display shows > 55% after one day's work, it is not necessary to recharge the battery before a second
similar day of work.
• The display shows 00% or a value very close to it, you must recharge immediately.
4.5. FITTING THE HOLSTER TO THE HARNESS
Note
The procedure is the same for right and left hand holstering. Only illustrations of the right side set-up are shown.
1. Detach the hook-and-loop strap (1).
2. Pull the hook-and-loop strap (1) away from the belt
loop (2).
14
To Next Page
Loading...