PELLENC BATTERY 250
56_158890-D
Note
The power-on LED lights up when the power is turned on and goes out when the power is turned off.
For more information about switching on and off with both tools, see 5.1. Usage method with both tools, page
17.
4.3. CHARGING THE BATTERY
Before using the battery for the first time in the season, perform a full charge.
Caution
Before connecting the charger to the mains, make sure that your mains supply corresponds to
the instructions on the charger (see 3.3. Technical characteristics - Charger, page 11).
When the battery is discharged, the tool stops automatically. The gauge display goes off, and the buzzer beeps
once. See 7.1. Recap of battery display messages and audible signals, page 22.
1. Make sure the battery is switched off, see 4.2. Switching the battery on and off, page 12
2. Install the charger and battery in an ventilated, dry
place with a temperature between 10°C and 25°C
and free from dust. Place the battery lying in a
horizontal position.
3. Connect the charger power connector (1) to the
electrical power outlet. The charger indicator (2)
lights up red.
4. Align the markers on the charging cable with the slot
on the battery charging connector.
5. Connect the charging cable (3) to the charging
connector (4) of the battery. The charger indicator
(2) lights up flashing green, and the battery indicator
(5) flashes orange.
13
To Next Page
Loading...