pellenc EXCELION 2 LH - TIME REMAINING BEFORE MAINTENANCE SERVICE

BRUSH CUTTER EXCELION 2 LH
53_154421-A
Note
If the data is insufficient when starting the tool for
the first time, the display will show "- - -".
This value cannot be reset.
-
5.5.3.5. DISPLAY OF THE TIME REMAINING BEFORE THE MAINTENANCE SERVICE
1. Click several times on the POWER/MENU but-
ton (5) so as to display the menu "5--MAINTE-
NANCE-HRS".
When the tool is started for the first time, the screen dis-
plays "500".
The screen displays a value in 10 hour increments.
Important
When the "time before service" counter reaches
50 hours, when the tool is started up, the main
screen displays a flashing pictogram symbolizing a
wrench.
When the counter reaches "0", when starting the
tool, the screen displays a fixed pictogram symbol-
izing the wrench.
In both cases, the tool must be serviced by an au-
thorized PELLENC distributor.
52