38 39|
MAINTENANCE AND CARE
CENTERING OR TENSIONING THE BELT
1 Power down and unplug the Tread.
2 Use a 6mm Allen key to tighten the tensioning screws on one or both sides of the belt
MAINTENANCE AND CARE CONTINUED
For more detailed instructions, visit support.onepeloton.co.uk.
y To pull the belt to the right, tighten the left screw one quarter turn
y To pull the belt to the left, tighten the right screw one quarter turn
y To add tension to a loose belt, tighten each screw one quarter turn
y For centering adjustments, run the Tread for 30 seconds to let the belt adjust.
y For tensioning adjustments, briey walk and run on the Tread to make sure the
belt isn’t slipping.
3 Turn on the Tread and test.
4 Repeat the adjustments as needed until the belt is tensioned and centered.
LUBRICATING THE BELT
The Peloton Tread belt comes lubricated from the factory and should not require additional
lubrication for 3 years.
Please refer to support.onepeloton.co.uk for latest instructions.
To Next Page
Loading...
