8-56 Command Reference
:MEASure :<Measuring Function>?
[8 [<parameters>][ ,(<channels>)]]
Make one measurement
The measure query makes a complete measurement, including configuration and
readout of data. Use measure when you can accept the generic measurement
without fine tuning.
+
When a CONFigure command or MEASure? query is issued, all counter settings
are
set
to
the
*RST settings.,
except
those
specified
as
<p
arameters>
and
<channels> in the CONFigure command or MEASure? query.
The :MEASure? query is a compound query identical to:
:ABORt;:CONFigure:<Meas_func>;:READ?
Parameters:
<Measuring Function>, <Parameters> and <Channels> are defined on page 8-54.
Y
ou
may
omit
<parameters>
and
<Channels>,
which
are
then
set
to
default.
Returned format: <data>¿
Where: The format of the returned data is determined by the format commands: :FORMat and
:FORMat:FIXed.
Example:
SEND®
:MEAS:FREQ? 8 (@3)
READ¬ 1.78112526833E+009
This example measures the frequency on the C-input and outputs the result to the
controller.
Type of command: Aborts all previous measurement commands if *WAI is not used.
See also: ‘Explanations of the Measuring Functions’ starting on page 8-59.
Complies with standards: SCPI 1991.0, confirmed.
To Next Page
Loading...
