Why is there no conditioned water after regeneration in my Pentair AUTOTROL 368 Control Unit?
If your Pentair Control Unit has no conditioned water after regeneration, it could be due to a lack of brine in the brine tank. Make sure to add brine to the brine tank. Alternatively, the injector might be plugged; clean the injector and screen.
What to do if Pentair AUTOTROL 368 Control Unit will not draw brine?
If your Pentair Control Unit isn't drawing brine, it might be due to a restricted drain line, so remove the restriction. Another possibility is a plugged injector; clean the injector and screen. Also, check if any debris is preventing the valve discs from closing and remove any foreign matter.
Why is there hard water leakage after regeneration in my Pentair AUTOTROL 368?
If your Pentair Control Unit is experiencing hard water leakage after regeneration, it could be due to several reasons. First, try repeating the regeneration, ensuring the correct brine dosage is set. If the issue continues, check for a leaking external bypass valve and replace it if necessary. Lastly, inspect the O-ring around the riser pipe for damage and replace if needed.
General| Model | AUTOTROL 368 |
|---|---|
| Type | Control Unit |
| Control Type | Electromechanical |
| Electromechanical | Yes |
| Power Supply | 120/240V AC |
| Voltage | 120/240V AC |
| Frequency | 50/60 Hz |
Details initial settings for installation including resin type, volume, and tank size.
Covers hydraulic parameters like injector size and refill controller number.
Specifies electrical parameters such as voltage and frequency.
Includes settings related to time of day, regeneration dosage, and capacity.
Defines the purpose and scope of the user guide, excluding installer information.
Provides manufacturer details, product model, and lists applicable norms and technical standards.
Details document release history and outlines Pentair's limitations of liability.
Identifies the location of safety tags on the device and ensures their legibility.
Addresses potential hazards, required personnel qualifications, and material safety precautions.
Recommends contact with dealer for sanitization and annual system disinfection.
Specifies the hydrostatic and working pressure, and the operational water temperature range.
Details acceptable environmental conditions including voltage, temperature, and humidity.
Guides through setting the time of day, brine dosage, and regeneration intervals.
Details how to set the desired capacity for regeneration for 606 controllers.
Explains setting days between regenerations for regulatory needs or flow sensor failure.
Recommends using EN973 certified salt pellets and avoiding rock or ice melt salts.
Notes that sanitizing may introduce chlorine, affecting resin life, requiring checks.
Initiates an immediate regeneration cycle, indicated by a cascading symbol.
Sets a delayed regeneration to occur at the next scheduled time, indicated by a blinking regen dot.
Allows skipping regeneration cycles to return the controller to service position.
Guides users on collecting information and contacting local dealers for technical assistance.
To Next Page
