Why Pentair AUTOTROL 368 Control Unit will not draw salt?
If the control unit won't draw salt, it could be due to several reasons. First, check for a restricted drain line and remove any obstructions. Second, the injector might be plugged, so clean the injector and screen. Finally, debris might be preventing the valve discs from closing; if so, remove any foreign matter from the valve discs.
Why is there hard water leakage after regeneration in my Pentair AUTOTROL 368?
If your Pentair Control Unit is experiencing hard water leakage after regeneration, it could be due to several reasons. First, try repeating the regeneration, ensuring the correct brine dosage is set. If the issue continues, check for a leaking external bypass valve and replace it if necessary. Lastly, inspect the O-ring around the riser pipe for damage and replace if needed.
What to do if Pentair AUTOTROL 368 Control Unit will not draw brine?
If your Pentair Control Unit isn't drawing brine, it might be due to a restricted drain line, so remove the restriction. Another possibility is a plugged injector; clean the injector and screen. Also, check if any debris is preventing the valve discs from closing and remove any foreign matter.
Why is there no conditioned water after regeneration in my Pentair AUTOTROL 368 Control Unit?
If your Pentair Control Unit has no conditioned water after regeneration, it could be due to a lack of brine in the brine tank. Make sure to add brine to the brine tank. Alternatively, the injector might be plugged; clean the injector and screen.
Why flow indicator on Pentair AUTOTROL 368 Control Unit does not display service flow?
If the flow indicator on your Pentair Control Unit isn't displaying service flow, it could be because the bypass valve is in the bypass position. Remove the bypass valve from the bypass position. Another potential cause is the meter cable being dislodged from the valve; fully insert the meter cable into the valve. Lastly, the meter might be clogged with debris, in this case, remove and clean the meter.
What to do if Pentair AUTOTROL 368 has flowing or dripping water at drain or salt line after recharge?
If there's flowing or dripping water at the drain or salt line after recharge, it could be that debris is preventing valve disc #3 or #4 from closing, so remove the debris. Alternatively, valve discs #3 or #4 might be worn and need replacement.
How to fix Pentair Control Unit recharging at the wrong time of day?
If the control unit is recharging at the wrong time of day, the Time of Day might be set incorrectly. Set the correct Time of Day to resolve this issue.
What to do if Pentair AUTOTROL 368 salt tank is overflowing?
If the salt tank is overflowing, ensure all salt line connections are tight. Another possible cause is a drain line restricted with debris, so you should clean the drain control.
What to do if Pentair AUTOTROL 368 drips water after regeneration?
If you observe flowing or dripping water at the drain or brine line after regeneration in your Pentair Control Unit, it could be because debris is preventing the #3 or #4 valve disc from closing. Remove the debris. Alternatively, the #3 or #4 valve disc might be worn and need replacement.
What does error E1 mean on Pentair Control Unit?
If your Pentair Control Unit displays "E 1", press any button. If "E 1" does not clear, replace the controller, as the program settings have been corrupted.
General| Model | AUTOTROL 368 |
|---|---|
| Type | Control Unit |
| Control Type | Electromechanical |
| Electromechanical | Yes |
| Power Supply | 120/240V AC |
| Voltage | 120/240V AC |
| Frequency | 50/60 Hz |
To Next Page
