Pentair AUTOTROL 368 - Programming Mode Chart

Installer manual Autotrol 368 (604-606) - Programming
Ref. MKT-IM-007 / D - 09.10.2020 33 / 60
3. Display Used to show informations, see Display [
→
Page32].
4. - Time button The time button when pressed will display the current hour of day
for 5seconds. Also used to change the time of day, see Time of
day [
→
Page34].
5. - Salt button The salt button when pressed will display the current salt setting
for 5seconds. Also used to change the brine dosage, see Brine
dosage [
→
Page34].
6. - Hardness button The hardness button when pressed will display the current
hardness setting for 5seconds. Also used to change the
volumetric regeneration, see Volumetric regeneration (606only)
[
→
Page34].
6.3 Programming mode chart
Parameter
description
Range of
values
Default
value
Units of
measure
Notes
Time of day 0:00- 23:59 12:00 hour:
minute
-
Brine dosage 0.2- 6.0 0.6 kg From 0.2kg to 1.0 kg by
increments of 0.05kg;
from 1.0 kg to 3.0 kg by
increments of 0.1kg;
from 3.0 kg to 6.0kg by
increments of 0.5kg.
Time clock
regeneration
(only604)
0  30 3 day 0= Disabled;
0.3= Regeneration every 8hours:
at 2, 10 and 18hours;
0.5= Regeneration every
12hours: at 2 and 14hours;
1- 30 = Regeneration every
Xdays.
Volumetric
regeneration
(only606)
0.4- 9.5 3.6 m
3
From 0.4m
3
to 1.0m
3
by
increments of 0.05m
3
;
from 1.0m
3
to 3.0m
3
by
increments of 0.1m
3
;
from 3.0m
3
to 5.0m
3
by
increments of 0.2m
3
;
from 5.0m
3
to 9.5m
3
by
increments of 0.5m
3
.