Pentair AUTOTROL 368 - Time of Day; Brine Dosage; Time Clock Regeneration (604 Only); Volumetric Regeneration (606 Only)

Installer manual Autotrol 368 (604-606) - Programming
34 / 60 Ref. MKT-IM-007 / D - 09.10.2020
Parameter
description
Range of
values
Default
value
Units of
measure
Notes
Calendar override
(only606)
0- 30 3 day 0= Disabled;
0.3= Regeneration every 8hours:
at 2, 10 and 18hours;
0.5= Regeneration every
12hours: at 2and 14hours;
1– 30= Regeneration every
Xdays.
System selection 1- 4 1 - See Programmed settings
[
→
Page35].
6.4 Time of day
Set the current time.
1. Press until desired hour appears then release.
ð Range from 0 through 23hours.
ð The elapsed minutes will reset to zero when the hours
are changed.
6.5 Brine dosage
Set the brine dosage.
1. Press until desired brine dosage appears then release.
ð Range from 0.2kg to 6.0kg;
from 0.2kg to 1.0kg by increments of 0.05kg;
from 1.0kg to 3.0kg by increments of 0.1kg;
from 3.0kg to 6.0kg by increments of 0.5kg.
6.6 Time clock regeneration (604only)
Set the time between each regeneration.
1. Press until desired brine dosage appears then release.
ð Range from 0 through 30;
0= Disabled;
0.3= Regeneration every 8hours: at 2, 10 and 18hours;
0.5= Regeneration every 12hours: at 2 and 14hours;
1– 30= Regeneration every Xdays (every 3 days in this
example).
6.7 Volumetric regeneration (606only)
Set the capacity in [m
3
] between each regeneration.