Pentair AUTOTROL 368 - Electrical Connections; Drain Line Flow Controller

Installer manual Autotrol 368 (604-606) - Installation
26 / 60 Ref. MKT-IM-007 / D - 09.10.2020
5.6 Electrical connections
AC transformer cable connection
Motor and optical sensor cable connection
Meter cable connection (368/606 only)
AC transformer connection
5.7 Drain line flow controller
The DLFC requires assembly before use.
Info
The plumbing connectors should not be installed. See Bypass assembly [
→
Page27]
1. Using a PTFE (plumber’s tape), wrap it over threads of the flow controller (2).
2. Screw the flow controller (2) and the 90° elbow (1) together (hand tighten).
3. Place the ball (5) into the flow controller (2) and insert the assembly into the drain line
opening (4).
4. Push the assembly in and secure with the drain line clip (3).