What to do if Pentair EVERPURE EVERDRI Industrial Equipment transmits electric current (electric shock)?
If the Pentair Industrial Equipment is transmitting electric current, creating a risk of electric shock, it is likely due to an installation that does not comply with local technical standards. Shut down the unit and call for service.
What to do if Pentair EVERPURE EVERDRI motor does not start or does not restart?
If the motor of your Pentair Industrial Equipment fails to start or restart, there could be several reasons: * There may be a voltage drop or no power to the unit, in which case you should wait for the power to return. * The circuit breaker might be turned off; turn it on. * The circuit breaker tripped because of circuit overload; call for service. * The electric motor could be damaged, requiring replacement of the compressor pump assembly.
Why Pentair Industrial Equipment has excessive starts?
Excessive starts or a runtime exceeding 500 hours in six months in your Pentair Industrial Equipment indicates leaks in the restaurant plumbing downstream of the compressor system. To resolve this, find and repair any leaks to reduce the demand for compressed air.
What to do if Pentair EVERPURE EVERDRI Industrial Equipment has water in tank?
If you find water in the tank of your Pentair Industrial Equipment, it could be due to a few reasons: * The coalescing filter may be failing to remove liquid water from the compressed air, in which case you should replace the coalescer filter assembly. * The coalescing filter water drain tube might be kinked or plugged; remove any kinks or obstructions. * The water drain tube may be improperly extended; remove the drain tube extension and drain directly under the enclosure.
What to do if Pentair Industrial Equipment motor does not shut off at or above cut-out pressure?
If the motor of your Pentair Industrial Equipment does not shut off at or above the cut-out pressure, it could be due to: * The tank pop-safety valve opens and relieves pressure, in that case replace the pressure switch. * Incorrect pressure switch settings, in that case adjust the pressure switch to meet specified cut-in and cut-out pressures.
How to fix insufficient air pressure in Pentair Industrial Equipment?
If your Pentair Industrial Equipment has insufficient air pressure, it may be caused by a pressure regulator that is not adjusted properly. Adjust the pressure regulator to achieve the specified outlet pressure.
General| Category | Industrial Equipment |
|---|---|
| Manufacturer | Pentair |
| Series | Everpure |
| Application | Compressed Air Drying |
| Filter Media | Desiccant |
| Flow Rate | Varies by model |
| Housing Material | Aluminum |
| Connections | NPT threaded or flanged |
| Model | EVERPURE EVERDRI |
To Next Page