Pentair FreshPoint Easy Flow User Manual

4 • Pentair FreshPoint Easy Flow User’s Guide
INSTALLATION INSTRUCTIONS
CONTINUED
2. Shut off the cold water to your faucet by turning the cold water valve under the
sink, clockwise.
3. Turn on cold water faucet to release pressure and drain water until water stops.
Leave faucet open.
NOTE: If the lter is removed from the unit for any reason, lter must be re-
installed. An audible click ensures proper sealing of the lter.
4. Place a tray or towel under the cold-water line to catch excess water. With
wrench, disconnect cold-water hose from cold-water line located near the water
shutoff valve (do NOT disconnect from the faucet).
5. Connect system cold-water inlet hose (white) to the cold-water shutoff
valve. Ensure tight connection (typically ve [5] turns).
6. Connect cold-water outlet hose (blue) to the cold-water hose still connected to
the faucet. Use a supplied wrench to hold the current hose tting while using the
second supplied wrench to tighten the tting on the blue hose.
PLACING THE SYSTEM INTO OPERATION
7. Wipe down system and area so it is dry, and to more easily identify potential
system leaks. Slowly open the water shutoff valve, by turning counter-clockwise,
while visually inspecting tting tightness to ensure no leaks.
8. Allow water to ow with faucet open completely for fteen (15) minutes to
ush the lter.
NOTE: A drinking water lter may contain carbon nes (very ne black
particles). If carbon nes appear in the water, continue ushing until none
are present.
NOTE: Initially, ltered water may appear cloudy. If cloudiness in glass of water
rises to the top, the cause is likely due to air in the water. The air (and cloudiness)
will disappear within a few weeks after installation.
9. Press and hold small Filter Life Indicator Button for ve (5) seconds. After
the button is released, a blue light on the Filter Life Indicator will ash four
(4) times to conrm timer has started.
FILTER LIFE INDICATOR
To check the remaining life of your lter, push Filter Life Indicator Button.
Blue Light:
Ea ch blue light ash indicates three (3) months of remaining lter life (e.g.
two [2] ashes represent six [6] months remaining life).
Red Light:
When the lter needs to be changed, a red light will blink three (3) times,
continuing three (3) times daily for eight (8) seconds for a period of 60 days,
unless deactivated by pressing the Filter Life Indicator Button.
If red and blue lights are ashing alternately, batteries need to be replaced.
After replacing lter, press and hold the Filter Life Indicator Button for ve
(5) seconds. The blue lights will ash four (4) times to indicate remaining life
of new lter.
3
2
4
5
6
9
7
8
ENGLISH

Pentair FreshPoint Easy Flow Specifications

General

Brand	Pentair
Model	FreshPoint Easy Flow
Category	Water Filtration Systems
Language	English