Pentair FreshPoint Easy Flow - Filter Replacement Procedure

Pentair FreshPoint Easy Flow User’s Guide • 5
1. Shut off the cold water to your faucet by turning cold-water
valve, under the sink, clockwise.
2. Turn on cold water faucet to release pressure and to drain
water from hose.
3. Press and hold Filter Release Button while holding rmly on
the base. Pull up on the exhausted lter to remove.
4. Insert the new lter into base of the FreshPoint Easy Flow
Water Filtration System. An audible click ensures proper
sealing of the lter.
5. Open water shutoff valve by turning counter-clockwise.
6. Allow water to ow with faucet open completely
for fteen (15) minutes to ush the lter.
NOTE: A drinking water lter may contain carbon nes
(very ne black particles). If carbon nes appear in
the water, continue ushing until none are present.
NOTE: Initially, ltered water may appear cloudy.
If cloudiness in glass of water rises to the top, the cause
is likely due to air in the water. The air (and cloudiness)
will disappear within a few weeks after installation.
7. Press and hold small Filter Life Indicator Button for ve
(5) seconds. A blue light on the Filter Life Indicator will
ash four (4) times to conrm timer has started.
2
1
FILTER REPLACEMENT INSTRUCTIONS
4
3
7
5
6
ENGLISH