Pentair HI FLOW SIX-WAY 1-1/2 INCH TOP MOUNT VALVE

Questions and Answers:

A
Anthony HarrisJul 28, 2025
What to do if Pentair HI FLOW SIX-WAY 1-1/2 INCH TOP MOUNT VALVE has a leak to waste port?
- M
  Melissa CoxJul 28, 2025
  If your Pentair Control Unit is leaking to the waste port, it could be due to dirt or sand under the seal. Try removing the valve top and cleaning the seal area. Another cause could be a damaged seal, in which case you should replace the valve top assembly. Finally, the valve body in the seal area might be damaged, requiring replacement of the valve body.
C
Carl MayerAug 2, 2025
Why is my Pentair Control Unit leaking at the handle?
- S
  Stephen JimenezAug 2, 2025
  If there's leakage at the handle of your Pentair Control Unit, it's likely due to leakage past the o-ring. The suggested solution is to replace the valve top assembly.
T
Timothy ShawAug 7, 2025
How to fix leakage at port connection to valve of Pentair Control Unit?
- A
  Alexandra ShepherdAug 7, 2025
  Leakage at the port connection to the valve on your Pentair Control Unit can stem from cracked ports. Replace the valve body, ensuring proper assembly and avoiding overtightening the port connections. Alternatively, insufficient sealant on the threads could be the issue; in this case, apply sealant.
J
Jeffrey WeberAug 12, 2025
What to do if Pentair Control Unit is leaking at the top of valve to valve body?
- M
  Megan HooverAug 12, 2025
  If your Pentair Control Unit is leaking at the top of the valve to the valve body, it's probably due to leakage past the o-ring. Remove the valve and inspect the o-ring and sealing surface, replacing them if necessary.
D
David GarciaAug 17, 2025
Why is there leakage at valve attachment to filter of Pentair HI FLOW SIX-WAY 1-1/2 INCH TOP MOUNT VALVE?
- C
  crystalsmithAug 17, 2025
  If you notice leakage at the valve attachment to the filter in your Pentair Control Unit, it's likely caused by leakage past the o-ring. Remove the valve and inspect the o-ring and sealing surface, replacing them if needed.
T
Tina RyanAug 21, 2025
How to stop leakage at sight glass with vacuum breaker on Pentair HI FLOW SIX-WAY 1-1/2 INCH TOP MOUNT VALVE Control Unit?
- D
  Danielle MurphyAug 21, 2025
  If your Pentair Control Unit is leaking at the sight glass with a vacuum breaker, it could be due to dirt on the sealing gasket. Remove the sight glass and rinse it with cool water to remove any dirt. If the sight glass is damaged, replace it.

Pentair HI FLOW SIX-WAY 1-1/2 INCH TOP MOUNT VALVE Specifications

General

Size	1-1/2 inch
Port Configuration	Top Mount
Mounting Type	Top Mount
Maximum Operating Pressure	50 psi
Valve Type	Multiport
Positions	6
Compatible Systems	Pentair Sand Filters