Pentair HYPRO 9300 Series - Page 24

20 1 2029-0014 Thrust Bearing Assembly
21 1 1610-0053 Square Key
22 1 0537-2500 Shaft
23 1 1810-0026 Snap Ring
24 1 1610-0055 Roll Pin
25 1 0150-2500C Motor Body (includes needle bearing)
26 4 2210-0005 Hex Head Cap Screw
27 2 1720-0110 O-ring
28 1 1600-0052 Dowel Pin
29 1 1600-0068 Dowel Pin
30 1 3900-0024 Gerotor
31 1 0702-2500C1 Gerotor Housing 1” wide
32 1 0254-2500C2 Motor End Plate (includes needle bearing)
33 4 2270-0039 Washer
34 4 2220-0044 Cap Screw
35 1 1720-0108 O-ring
36 1 3360-0021A Pressure Port Adapter (includes o-ring)
37 1 3320-0051A Tank Port Adapter (includes o-ring)
38 1 1720-0262 O-ring
39 1 3220-0029 Bypass Adjusting Screw
40 1 1700-0047 Gasket
41 1 2270-0027 Washer
42 1 2250-0038 Lock Nut
1 1 2406-0002 1/2” NPT Drain Plug
2 1 3430-0481SP Self Priming Chamber (SP model only)
Includes a stainless wear ring, plugs, & o-ring
2 1 3430-0481BSP Self Priming Chamber (BSP model only)
Includes a stainless wear ring, plugs, & o-ring
3 1 2406-0034 1” NPT Prime Port Plug (SP model only)
3 1 2406-0036 1” BSP Prime Port Plug (BSP model only)
4 1 2253-0002 Impeller Nut
5 1 2270-0071 Washer
6 1 0403-9200P1 Impeller
7 1 1700-0100 Rubber Gasket
8 1 2120-0009 Mechanical Seal (Viton/Ceramic) (Std 9305C)
8 1 3430-0601 Mechanical Seal (Silicon Carbide) (Optional)
9 1 1720-0180 O-ring
10 1 0752-9200C Mounting Flange
11 6 2210-0086 Hex Head Cap Screw
12 1 1410-0056 Slinger Ring
13 1 1810-0014 Snap Ring
14 1 1820-0013 Retaining Ring
15 1 2000-0010 Ball Bearing
16 1 1410-0131 Cartridge, Front
17 2 1720-0268 O-ring
18 1 2104-0010 Lip Seal
19 1 1410-0130 Seal Spacer
Models 9305C-HM3C-SP and 9305C-HM3C-BSP
NOTE: When ordering parts, give
QUANTITY, PART NUMBER,
DESCRIPTION, and COMPLETE
MODEL NUMBER. Reference
numbers are used ONLY to iden-
tify parts in the drawing and are
NOT to be used as order numbers.
Parts Kit No. 3430-0748
Contains: One each ball bearing
(Ref. 15), motor shaft seal (Ref.
18), thread seal gasket (Ref. 40),
two cartridge o-rings (Ref. 17) and
washer (Ref. 41); two each motor
housing o-rings (Ref. 27), and port
adapter o-rings (Ref. 35 & 38).
Ref. Qty.
No. Req’d. Part No. Description
Hydraulic Motor Part No.
2500-0083C
Ref. Qty.
No. Req’d. Part No. Description
Repair Parts Kit No. 3430-0500
Contains one each: mechanical seal
(Ref. 8), o-ring (Ref. 9), and rubber
gasket (Ref. 7).
Silicon Seal Kit No 3430-0601
Contains one each: mechanical
seal (Ref. 8) and o-ring (Ref. 9).
-24-
L-1526 (12/12, Rev. B)