4
L-1600 (04/01/21)
SAFETY INFORMATION
Do not pump at pressures higher than the maximum
recommended pressure.
Operate the pump between a temperature ranges of 45° to
140°F [7° to 60°C].
Make certain that the power source conforms to the
requirements of your equipment.
Provide adequate protection in guarding around the moving
parts such as shafts and pulleys.
Disconnect the power before servicing.
Release all pressure within the system before servicing any
component.
Drain all liquids from the system before servicing.
Secure the discharge line before starting the pump. An
unsecured discharge line may whip, resulting in personal
injury and/or property damage.
Check all hoses for weak or worn condition before each use.
Make certain that all connections are tight and secure.
Periodically inspect the pump and the system components.
Keep free of debris and foreign objects.
Perform routine maintenance as required (see
maintenance).
When wiring an electrically driven pump, follow all
electrical and safety codes, as well as the most recent
National Electrical Code (NEC) and the Occupational Safety
and Health Act (OSHA) requirements.
Use only pipe, hose, and hose fittings rated for maximum
rated pressure of the pump or the pressure at which the
pressure relief valve is set at. Do not use used pipe.
Do not use these pumps for pumping water or other liquids
for human or animal consumption.
Do not pressure feed pump inlet.
Do not touch an operating motor. Modern motors can
operate at high temperatures.
Do not handle pump or pump motor with wet hands or when
standing on wet or damp surface, or in water.
HAZARDOUS SUBSTANCE ALERT
1. Always drain and flush pump before servicing or
disassembling for any reason (see instructions).
2. Always drain and flush pumps prior to returning unit for
repair.
3. Never store pumps containing hazardous chemicals.
4. Before returning pump for service/repair, drain out all
liquids and flush unit with neutralizing liquid. Then, drain
the pump. Attach tag or include written notice certifying
that this has been done.Please note that it is illegal to
ship or transport any hazardous chemicals without United
States Environmental Protection Agency Licensing
To Next Page
Loading...
