EasyManua.ls Logo

Pentair Hypro Series - Page 39

Pentair Hypro Series
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- 39 -
EC Declaration of Incorporation
Manufacturers Name: Pentair Flow Technologies, LLC
Manufacturers’ Address: 375 Fifth Avenue NW,
New Brighton, MN 55112, USA
Declare that the partially complete machinery described below conforms to applicable health and safety
requirements of Parts 1 of Annex I of Machinery Directive 2006/42/EC. This partly completed machinery must not
be put into service until the equipment into which it is to be incorporated has been declared in conformity with
the provisions of this directive. Confidential technical documentation has been compiled as described in Annex
VII Part B of Machinery Directive 2006/42/EC and is available to European national authorities on written request.
If a request is received, documentation will be transmitted either electronically or by post. Clauses 1.1.4, 1.1.7,
1.1.8 Section 1.2, Clauses 1.3.5, 1.3.6, 1.3.7, 1.3.8.1, 1.3.8.2, 1.3.9, 1.4.1, 1.4.2.1, 1.4.2.2 1.4.2.3, 1.4.3, 1.5.2, 1.5.7,
1.5.12, 1.5.14, 1.5.16, 1.6.2, 1.7.1.1, 1.7.1.2, 1.7.2, and 1.7.4.2 are clauses of Machinery Directive 2006/42/EC that
have not been met, but could be applicable and must be addressed during installation by a third party.
Description: PENTAIR Pump
Type: Roller Pumps
Series Numbers: 1502, 1700, 4001, 4101, 6500, 7560, 7700
The following standards have either been referred to or been complied with in part or in full as relevant:
ENISO 12100 Machinery Safety - General principles for design - Risk assessment and risk reduction
EN809-1998 + A1 2009 Machinery Safety - Pumps and pump units for liquids - Common safety requirements
EN ISO 13732-1 Machinery Safety - Ergonomics of the thermal environment
EN ISO 3744:2010 Acoustics - Determination of sound power levels and sound energy levels of
noise sources using sound pressure
EN ISO 11202/A1 1997 Machinery Safety - Noise emitted by machinery and equipment
EN 12162:2001+A1:2009 Machinery Safety - Liquid pumps - Safety requirements -Procedure for hydrostatic
testing
EN ISO 4254-6:2009 Machinery Safety - Sprayers and liquid fertilizer distributors
Name .......... Position ...
Signature ....... Date ......
Place of Signing..
EC REP
QNET BV
Hommerterweg 286
6436 AM Amstenrade
The Netherlands

Related product manuals