OPERATING THE PUMP 5/20
SET MAXIMUM SPEED RPM
The maximum speed can be set from 1900 RPM to 3450 RPM (default is 3450). Use this setting
to set the maximum running speed of the IntelliFlo
®
VSD2 Variable Speed pump.
1. Check that the green power LED is on.
2. Press menu.
3. Press select to select “Settings”.
4. Use the up or down arrows to scroll to “Min/Max”.
5. Use the up or down arrows to scroll to “Set Max Speed”.
6. Press select to change. The cursor will appear in the first number column.
7. Press up or down arrows to change the maximum speed setting from 1900 till 3450 RPM.
8. Press save, to save. Press back to exit. To cancel, press back to exit without saving.
Note: Maximum speed will limit priming speed, except in one case. If the maximum speed
is set below the lowest available Priming Speed (2400 RPM) then the pump will exceed the
maximum speed while the priming feature is running. This prevents the pump from having
trouble priming if the maximum speed is set this low. If this is a problem, priming can be
disabled in the priming menu (see “Priming” section later on this manual).
PUMP ADDRESS
The default pump address is #1 and only needs to changed when there is more than one
pump on an automation system. Change the address to allow the automation system to send
a command to the correct pump.
Use this setting if your pump is connected via the RS-485 COM port to the IntelliPool
®
control
system or IntelliComm
®
communication center. For IntelliPool
®
or IntelliComm
®
systems,
the pump only communicates with address #1. The pump address can be set from 1-16. The
IntelliPool
®
system can communicate to only four (1-4) pumps.
Note: IntelliFlo VSD2 pumps cannot be connected in series with other pumps.
1. Be sure the green power LED is on and the pump is stopped.
2. Press menu.
3. Press select to select “Settings”.
4. Use the up or down arrows to scroll to “Device” and press select.
5. Use the up or down arrows to scroll to “Pump Address” and press select.
6. Press up or down arrows to change the address number from 1-16.
7. Press save to save. To cancel any changes, press back to exit without saving.
8. Press back to exit.
16
To Next Page
Loading...
Need help?
General
