INTELLIFLO
®
VS+SVRS and INTELLIPRO
®
VS+SVRS Variable Speed Pump Installation and User’s Guide
v
For hot tubs and spa pumps, do not install within an
outer enclosure or beneath the skirt of a hot tub or
spa unless so marked.
IMPORTANT PUMP WARNING AND SAFETY INSTRUCTIONS
Pumps improperly sized or installed or used in
applications other than for which the pump was
intended can result in severe personal injury or death. These risks
may include but not be limited to electric shock, fire, flooding, suction
entrapment or severe injury or property damage caused by a structural
failure of the pump or other system component.
The use of alcohol, drugs, or medication can greatly
increase the risk of fatal hyperthermia in hot tubs
and spas.
To reduce the risk of injury, do not permit children to
use this product unless they are closely supervised
at all times.
For units intended for use in other than single-family
dwellings, a clearly labeled emergency switch
shall be provided as part of the installation. The switch shall be readily
accessible to the occupants and shall be installed at least 5 feet (1.52m)
away, adjacent to, and within sight of, the unit.
When setting up pool water turnovers or flow rates
the operator must consider local codes governing
turnover as well as disinfectant feed ratios.
A clearly labelled emergency shut-off switch for
the pump must be in an easily accessible, obvious
place. Make sure users know where it is located and how to use it in
case of emergency.
Install the pump a minimum of five (5) feet from
the inside wall of the pool and spa. Canadian
installations require a minimum of three (3) meters from pool water.
A No. 8 AWG or larger conductor must be wired to
the motor bonding lug.
This pump is for use with permanently installed
pools and may also be used with hot tubs and
spas if so marked. Do not use with storable pools. A permanently
installed pool is constructed in or on the ground or in a building such
that it cannot be readily disassembled for storage. A storable pool is
constructed so that it may be readily disassembled for storage and
reassembled to its original integrity and has a maximum dimension of
18 feet (5.49m) and a maximum wall height of 42 inches (1.07m).
IntelliFlo
®
VS+SVRS Pump is capable of generating
systems pressures up to 50 psi. Installers must
ensure that all system components are rated to withstand at least 50
psi. Over pressurizing the system can result in catastrophic component
failure or property damage.
Two Speed Pump Controls Notice (Title 20 Compliance)
Please read the following important Safety Instructions (See page 16 for pump speed setup). When using two-speed
pumps manufactured on or after January 1, 2008, the pump’s default circulation speed MUST be set to the LOWEST
SPEED, with a high speed override capability being for a temporary period not to exceed one normal cycle, or two
hours, whichever is less.
To Next Page
Loading...
Need help?
General
